The KiwiSDR 2 online store is open for orders! Please visit kiwisdr.nz
Please visit kiwisdr.com (documentation) and kiwisdr.nz (online store)
KiwiSDR waterfall stops when running WSPR extension
Running latest firmware, if I run the WSPR extension the sole Kiwi on my hard wired home LAN will stop, as in the waterfall and zoomed waterfall stop, BUT the revolving WSPR timer continues to time. I have to close the link and run again. I did have the wspr daemon running on a Pi but shut that down and it still plays up. I will test without the WSPR extension running, but suspect it still freezes. Any suggestions please, thanks, and a very healthy and happy Christmas to all on the reflector.
Comments
Greeting All
I have the same problem using the latest SW upgrade, v1.544 (older version too), when running the WSPR Extension while RX0 is running WSPR-Autorun. It runs for a while and then the screen freezes and I have to reload the webpage.
Also experiencing WF audio underflow blinking message during the screen freeze.
Sure would like to get this 'fixed'...
73 Dick/w7wkr