The KiwiSDR 2 online store is open for orders! Please visit kiwisdr.nz
Please visit kiwisdr.com (documentation) and kiwisdr.nz (online store)
Nationwide_3
About
- Username
- Nationwide_3
- Joined
- Visits
- 30
- Last Active
- Roles
- Member
- Points
- 1
Comments
-
In answer to the Admin access. Yes, from the local network I run the Kiwi on, that’s why I was confused. I can now access Admin and externally connect to my Kiwi. Thanks
-
I’ve just reset the Kiwi and everything appears to be fine. I will set up a password now. Thanks.
-
Thanks, post edited. I would add password if I could access Admin. Ta
-
A big thank you to John and Stu for sorting this problem out for me. Best Regards to both of you! Glenn
-
Hi John, send you an email via Support. Thanks
-
Perfect, TeamViewer is fine. Thanks
-
I'm not sure how to open port. No update happened over night. Is there a support telephone number ? Thanks
-
Will have a go in the morning. Thanks
-
Hi, There is 5.06v voltage to the board. On the admin interface there is no console tab ?? Thanks
-
In answer to the card. It hasn't been fitted at all. The instructions stated that the software was preloaded if the board and sdr were purchased together. Thanks
-
Hi Martin, thanks for the reply. I will leave it running overnight as you suggest. I only installed it today and purchased it with the reccomended power supply. Thats not to say its working properly. I will check the voltage output if no different…
-
I have been doing that. Sometimes it doesn't always find the page. Reload again and the page loads but the status is the same.