ricardo

Comments

• would be 2 dipole antennas: one north south, another east-west

  in TX near the kiwi Comment by ricardo July 2020
• if the power cable runs close to, near, or close to the network cable, you will experience interference problems.(Image)

  in Noise at roughly 60 KHz intervals Comment by ricardo June 2020
• Hello, see the result of a balun of air nucleus in my apartment.very simple. about 10 turns.cleaned a lot of dirt https://www.youtube.com/watch?v=RHLLQHXEhLE&feature=youtu.be

  in Noise at roughly 60 KHz intervals Comment by ricardo June 2020
• Eric, i'm on a farm and i have the same noise as you, like rtty. if I leave the network at 100mb.se step to 10mb the noise disappears

  in Noise at roughly 60 KHz intervals Comment by ricardo May 2020
• OK

  in My Kiwisdr does not start properly after installing the aluminum enclosure Comment by ricardo May 2020
• I tried a 100 meter network cable and it didn't work. What is the largest possible network cable?

  in My Kiwisdr does not start properly after installing the aluminum enclosure Comment by ricardo May 2020
• hi, my kiwi does not appear on sibamanna and is listed on sdr.hu. thank you Ricardo http://py4aaz.homeip.net:8073/

  in rx.linkfanel.net receiver map moving to Leaflet Comment by ricardo May 2020
• I got a lot of white noise and vertical lines, using a 30 + 45 meter long network cable with a switch in the middle. currently using 30 meters of network cable and dipole antenna .. signal was very clean .. lowering the settings to 10mbs made a lot …

  in Noise at roughly 60 KHz intervals Comment by ricardo May 2020