Comments
-
I sent you an e-mail. Did it go through? I'm using AOL. No matter what I try, I cannot get SAM working like it used to before the update. BTW, I rebooted the SDR earlier today, because I couldn't select any mode, AM, SAM, etc... it was just "st…
-
Noise blankers are all off.
-
I have an idea... my SDR is "semi private", accessed online via my ISP's IP address. I would e-mail it to you, so you can log in an check out what's happening. I don't want to post my IP openly, for obvious reasons. ;)
-
OK, Channel Null only has 3 settings, and I tried all of them. There is no "OFF" or I would try that. Stronger signals get distorted, VERY strong signals (Over S30) fade out to very low volume & distorted. I tried "med" and &…
-
Channel nulling? Hmmm... that must be new! I tried turning various pre-emp, noise, etc, on and off. Nothing had any effect. The signals are strong. Some weaker ones also do this. This only started happening after I installed this recent update. I w…
-
Ah! I'm glad I checked in to the Forum, because I was noticing some errors regarding automatic updates. I concur with the idea of "Binary Only" updates... MUCH easier for end users. :) So far, so good... "update_fix" is running …
-
For some of the guys complaining about bots logging in and monitoring a specific frequency, this method will fully thwart them! I was very annoyed by a nearly CONSTANT stream of totally un-decodable RTTY at 4005 KHz, so I created the "mask"…
-
The site isn't so bad, tho! :)
-
Oh! how did I not see that? Thanks! I just tweaked it! :)
-
I just now installed the update, and I can confirm that the +/- 5KHz is now only moving 1KHz. :(