S meter averaging? [fixed in v1.290]

pjepje
edited June 2019 in WSPR, wsprdaemon, kiwirecorder
Hello,

Fabulous job on the KiwiSDR front end software.

When using the "S-meter graph" is there any way to increase the integration time for each point plotted? Perhaps this is related to the settings in the main RX window, but I couldn't quite figure it out.

73
Phil W1PJE
WA2ZKD

Comments

  • jksjks
    Okay, this was relatively easy and will be in the next release.
    PowernumptyHB9TMC
  • djacobsdjacobs
    @jks the S-meter option says it reports the s-meter value after S_METER # of averages. It says that it takes about 6 samples per second, so if I want to report 1 value per minute, I would guess that I should do S-meter=360 (60 seconds * 6 samples/second). However, S-meter=60 seems to give me 1 value per minute.
  • jksjks
    No, 6 samples/sec is roughly what you get in non-averaging mode (S-meter=0, the default). A non-zero value for S-meter= is the number of seconds of averaging, independent of exactly how many averages that turns out to be.
  • djacobsdjacobs
    I see, that makes sense. The --help option seems to indicate otherwise.
  • jksjks
    Are you using the most recent version?
Sign In or Register to comment.