It looks like you're new here. If you want to get involved, click one of these buttons!
Software release information
Configuration and Operation
Installation, Antennas and Interference
WSPR, wsprdaemon, kiwirecorder
Problems and Issues
Problems Now Fixed
INFO NEEDED [label creation/editing, overload detection]
edited March 2019
As a new KIWI user, PSE inform me how can I detect that my KIWI is RF overloaded from out of HF band sigs??
Also how can I maybe have some freq/mode memories (further the one on startup)??
jks THANKS A LOT for related info...
Hi again jks. Can you maybe advice further please, how can I increase permanently the standard
bandwidth, say from 2700 to 3300Hz, when I create a new id-user-marker??
You can do this when you create or edit a label using the panel that pops-up when you shift-click the label. Enter a custom passband into the "passband" field to the right of the mode field. E.g. "300, 3300" will give you a 3000 Hz wide passband from 300 - 3300 Hz (USB).
jks TNX again for fast reply and advice...All set OK
Forum Software Powered by Vanilla