Comments
-
yes, I spared the marked red "Do not use!" pins and it survived full 180° connected to the green area... so p8 was connected to p9 (no shift outside of the green area)... "survived" in a sense that the board is now detected, show…
-
I now tried everything.. measured the beagleboard without kiwi board etc and then realised after a while ... well, cough ... I managed to spare the right pins, but all I can say 180° ... /me hides. Now everything works. Sorry for the confusion and t…
-
@studentkra its a cheap 27 years old multimeter ... not sure what it actually does
-
@studentkra the board was never used before... ordered it as extra board and didn't use it before... it was stored disassembled and safely packed inside the house. No thunderstorm or anything else should have touched it so far. low resistance as too…
-
ok. I'll test with another BB ... gave the BBG Kiwi-2 to a friend... either I'll get that back for testing or I'll get another BBG or BBAI64. This will take some days. I'll come back. Thanks so far!
-
the kiwi board was never used before ... ordered it as an extra board end of 2023 and got it beginning of 2024 together with a completely assembled BBG KiwiSDR 2. Use the assembled kiwi so far and now found the time to get the extra board attached t…
-
The resistance measure result against ground: 3.3A: 420 Ohm 1V: 143 Ohm 1.8V: 430 Ohm 3.3G: 572 Ohm 5V in: infinite 3.3V GPS: 1067 Ohm 3.3V: 416 Ohm 5VE: infinite 5V: 470 Ohm Thanks!
-
I am interested in 2 pieces of KIWI 2. Thanks!