Holger
About
- Username
- Holger
- Joined
- Visits
- 272
- Last Active
- Roles
- Member
- Points
- 1
Comments
-
The KiwiSDR has a low pass filter. Anything above 30 MHz is cut off. (See the Schematic, Page 2) http://kiwisdr.com/docs/KiwiSDR/kiwi.schematic.pdf Check out Openwebrxplus, running on an Raspberry Pi 4, as an alternative. It also offers many option…
-
Same problems here (KiwiSDR 2, v1.686). No Upload from the Extension. Only with Auto-Run.
-
The integration of FLDIGI decoders sounds like a good plan. MFSK and PSK are digital modes that can still be found on the bands. Pharos Ignis (aka PI4) should perhaps also be considered as this mode for beacons is becoming established.
-
In almost 40 years of amateur radio, I have seen many digital operating modes come and go. Basically I just miss the ability to decode PSK31 and some submodes, maybe JT65. For the rest you can use external programs such as Multipsk. 73s Holger, DF6D…
-
Tuning the frequency using the mouse wheel is, in my humble opinion, much easier. Implementing it by simply reprogramming inexpensive USB volume controls is very easy, as in the example here in this link: https://www.youtube.com/watch?v=_sxHZujkXbg …
-
Seems ok now. https://forum.kiwisdr.com/uploads/639/P2IDDZVHYYXG.png 73s Holger, DF6DBF
-
Thanks for your quick help! :) 73s Holger, DF6DBF
-
Hello Pekka, i use Openwebrx (plus) in parallel to my KiwiSDR2 and like the tuning via the Mouse Wheel very usefull. Have you find out how to use the Mousewheel with the KiwiSDR to? 73s Holger, DF6DBF