The forum is read-only currently.

Case assembly video

Not sure if this link has been seen.
www.youtube.com/watch?v=gXdKZNuQNT4&t=311s

I'm sure there is a better way to do the post washers than "balancing them" before offering up the base.
Perhaps a comment on the video might help someone else putting the case together.

I've no link to the poster just saw it from another video.

Comments

  • edited November 2019
    I didn't do it that way.... I put the FH screws in case put a piece of tape over them, put star washer over them, dropped board stack on, then tightened the FH screws. I have done about 10 kiwi that way
  • That's probably how I'd have done it, there are few other ways but balance? Nah.
Sign In or Register to comment.